Publicidad
Idiomas disponibles
Idiomas disponibles
3. Set the Timer; the convection fan(s) and oven lights will
operate continuously.
4. Place food into the unit and monitor. NOTICE: Do not set
heavy pans or other items onto the door when opened.
This could damage the door and hinges.
Broil Mode (CO4-208240HS & CO4-120HS )
1. Place wire shelves or pans in desired positions inside the
unit, allowing at least 2" (5cm) between each, and ensuring
food will not contact the top heating element.
2. Turn Bake Control to Broil; Convection Fans will not operate.
3. Set Broil Control to desired temperature; Bake Timer is not
used in this mode.
4. Place food into the unit and monitor.
Steam Function (CO4-208240FS Only)
This function creates heavier crusts on bread and rolls; it works
best if activated at the beginning of baking, after cooking
temperature is reached and food has just been placed.
1. Press the Steam Button for two seconds or less to spray a
small amount of water into the cooking chamber.
CLEANING
Fire Hazard, Injury, or Property Damage.
Overheated grease, oil, or fat vapors can
cause a fire. Unit must be cleaned daily.
Electrical Shock Hazard.
Keep water and other liquids from entering the
unit. Liquid inside the unit could cause an electrical
shock or short circuit.
Do not immerse the cord, plug, or unit in water or
any other liquid—or operate if the unit or cord are
damaged or altered.
Burn Hazard.
To avoid burns and splattering, do not touch
cookware, heating surfaces, or food—or drop
water onto cooking surfaces while operating.
NOTICE:
Do not use caustic cleaning chemicals, steel wool or
commercial products to clean the unit.
3
WARNING
WARNING
WARNING
Countertop Convection Ovens
1. Turn off and unplug the unit.
2. Protect your hands and remove hot food.
3. Allow unit to cool completely.
4. Remove wire shelves and racks. Wash, rinse, and
thoroughly dry components before reinstalling.
NOTICE: For half-size models with rubber feet, the door
must be removed before lifting unit to clean underneath
the oven. See Removing the Door section below.
5. Clean unit with mild soap and water to remove grease & oil.
6. Dry unit before installing the wire shelves and racks.
Removing the Door
1. Turn off and unplug unit and allow it to cool completely.
2. Open door to locate vertical locking tabs on the hinges; use
your finger to pull locking tabs so they are horizontal.
3. Slowly close the door until it will not close any further; then
lift up on the door so hinges release from receivers.
Installing the Door
1. Line up the slot at the bottom of each hinge with the
receiver front so that hinges drop into place.
2. Fully open the door to the horizontal position.
3. Push Locking Tabs back to the vertical position.
4. Close the door to ensure it is working properly.
3
Publicidad
