Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
PRODUCT SPECIFICATIONS
Speed ....................................................0-2,700/min. RPM
Chuck ................................................................1/4 in. Hex
ASSEMBLY
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
OPERATION
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
„ Driving, tightening, and removing screws, nuts, and bolts
Impacts per minute ................................ 0-3,800/min. IPM
Torque ............................................................. 0-950 in.lbs.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
OVERLOAD PROTECTION
When the tool is forced or overloaded, the Li-ion battery
pack will automatically shut off the tool. To reset the tool,
release the trigger and resume operation. If the tool still does
not resume operation, remove and reinsert the battery. Do
not force the tool.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the battery
and tool to cool and then squeeze the trigger.
INSTALLING/REMOVING BELT HOOK
OR BIT HOLDER
See Figure 1, page 8.
The belt hook (p/n 636181001) and bit holder (p/n 539462001)
are interchangeable. They may be installed on either side of
the base. Look for these accessories where you purchased
this product or call 1-866-539-1710.
„ Align hole in belt hook or bit holder with hole in tool's base.
„ Install screw to secure belt hook or bit holder in place.
„ To uninstall, remove screw and then belt hook or bit
holder.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 8.
„ Lock the switch trigger by placing the direction of rotation
selector in the center position.
„ Insert the battery pack into the battery port as shown.
„ Make sure the latches on the battery pack snap into place
and the battery pack is secured in the product before
beginning operation.
5 - English
Publicidad
