Speed: Sets the dehumidifier power to high or low speed when in Normal Mode.
Timer: Set a turn-on or shut-off timer, between 1-24 hrs.
•
Setting a Turn-On timer: When the dehumidifier is off, tap the timer button until you reach
the desired number of hours before you want it to turn on. The 'Hr' light will light up when a
timer is set.
•
Setting a Turn-Off timer: When the unit is on, tap the timer button until you reach the
desired number of hours required before it turns off. The 'Hr' light will light up when a timer is
set.
Child Lock: This button will lock the controls for child safety. Press and hold the button for 3
seconds to lock and unlock.
Fan: Turns off the dehumidifying function so that only the fan runs.
Display: Press this button to send the display to sleep. The unit will continue working but the
lights will turn off.
Defrosting Light: Indicates when the unit is defrosting.
Humidity Indicator light: This is an indicator of the current air humidity:
•
Red: Humidity more the 70%
•
Green: Humidity between 50% -70%
•
Blue: Humidity below 50%
CONNECTING THE WATER HOSE FOR CONTINUOUS DRAINING
― ―
For long term use it is recommended to connect a hose for continuous drainage.
1.
Remove water tank.
2.
Insert the hose into the water hose connector, ensuring it is connected properly.
3.
Ensure the hose end has a suitable drainage outlet (e.g. a drain or bucket).
4.
Slot the tank back in carefully.
REMOVING AND EMPTYING THE WATER TANK
― ―
When the water tank is full the red indicator light will flash and the product will make a beeping
sound. The dehumidifying function will automatically stop. Press the ON/OFF button to turn off
the dehumidifier before removing the water tank.
1.
Gently pull the water tank out from the back of the dehumidifier.
2.
Use handle to empty the water tank.
3.
Once empty, slot the tank back in carefully.
10 of 64 | English
HANDLE
CLEANING AND STORAGE
― ―
WARNING: ALWAYS TURN THE APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE APPLIANCE, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS THIS CAN DAMAGE THE APPLIANCE.
Do not attempt to clean the appliance in any other way
•
than that detailed by the manufacturer.
Clean the exterior surface of the appliance by wiping
•
it with a soft, damp cloth. Dry the appliance with a soft,
clean cloth.
The filter should be cleaned every two weeks using a
•
damp cloth
Always empty the water tank, clean and dry the
•
appliance when not in use to prevent mould.
English | 11 of 64