WALMEC Walcom 360 True Light Evo Meter Instrucciones página 11

TECHNICAL DATA
Operating temperature
Maximum weight with battery inserted
Internal diameter reductions
(refer to the link indicated in section 3.
Installation for the relevant reduction/spraygun
association)
Luminous flux (range)
Color temperature
CRI
Internal battery
Charging time
(from completely discharged battery)
Average number of complete charging cycles
OPERATING MALFUNCTIONS AND REMOVAL OF THE CAUSES
Anomaly
The light does not turn on
The light does not turn on
and does not charge
Battery life is reduced
The protective glass is
damaged
The light does not get
stuck in the spraygun
During the charging phase
the light flashes constantly
and the writing "NO
BATTERY" appears on the
display
Distance detection does
not work properly
CARE, MAINTENANCE AND REMOVAL FROM SERVICE
In order to guarantee the functioning of the 360 TRUE LIGHT EVO METER light over time, carry
out cleaning and maintenance at regular intervals, scrupulously following the maintenance and
cleaning plan.
It is advisable to keep the protective glass and the internal glass of the LEDs clean, together with
regular care/maintenance and storage of the product.
Pay attention to the management of the battery, in terms of periodic charges and temperatures
of use: inconsistent use and with temperature peaks compromises the life of the battery and the
relative number of recharge cycles.
Follow local regulations/legislation for the disposal of the battery and the product when it is
taken out of service.
Causes
Low battery
Battery does not make
contact with the metal
connectors or is inserted
incorrectly
Battery to be replaced
Ruined/scratched slide
Use of incorrect
reduction;
The rubber reducer is
worn or damaged
Battery disconnected or
not working
Damaged/dirty sensor
protection film
11
0° C +35°C
Without magnet support: 173 g
Including magnet holder: 198 g
A= 42.5 mm
E= 41.5 mm
B= 40 mm
C= 36.5 mm
D= 33 mm
200 ÷ 600 lumen
6500 K
>= 97 CRI at maximum light intensity
Li-Ion, 18650, 3400 mAh
4/6 hours (with 5V power supply and at
least 1 A)
300 ÷ 500
Remedy
Charge the battery
Check that the metal connectors of
the battery holder are in contact with
the relevant battery poles and that the
battery is correctly inserted
Replace the battery
Replace the protective glass
Choose the size of the most suitable
rubber reduction;
Replace the reduction with a new one
Check that the metal connectors of the
battery holder are in contact with the
relevant battery poles and that the batte-
ry is correctly inserted
Check that the metal connectors of the
Replace the distance sensor protection
film (13)
EN