WALMEC Walcom 360 True Light Evo Meter Instrucciones página 9

INSTRUCTIONS FOR USE
AT EACH USE, check that the sensor (13) and display (14) protection films are not dirty and/or
detached. Replace the films immediately when they are dirty and/or detached. Dirt on the sensor
affects the detection accuracy of the distance sensor!
Position the 360 TRUE LIGHT EVO METER light on the ring, making sure that the cap and the
initial portion of the ring are positioned completely outside the protective glass (fig. 2) and not
just partially (fig. 3). Check that the 360 TRUE LIGHT EVO METER system is firmly locked to
the aircap ring.
(fig. 2)
Once switched on, by pressing the ON/OFF button (quick double click), it is possible to turn the
LED light ring off/on while keeping the distance detection system active.
To adjust the light intensity, hold down the ON/OFF power button (first ramp=increase in light
intensity, second ramp=reduce light intensity).
To turn off the light, briefly press the ON/OFF power button.
Low battery: during operation, a brief flash of the LEDs means that the battery charge is not suf-
ficient to maintain the set brightness and therefore the light intensity is automatically reduced to
maintain the maximum brightness allowed by the remaining battery charge. To avoid flashing, you
can manually decrease the light intensity by holding down the power button.
On the display it is possible to check the remaining battery level, evaluated with respect to the set
light intensity, visible with the battery level indicator in position (B) in fig.5b.
Charging phase: before proceeding with charging, carefully read the SAFETY WARNINGS in order
to prevent personal damage, fires or accidental explosions.
Remove the protective cap of the USB-C connector and connect the supplied cable to the 360
TRUE LIGHT EVO METER light and to the USB power supply (5V and at least 1A).
During the charging phase the LEDs flash as follows:
- 1 flash every 5 seconds: battery charged from 0% ÷ 33%
- 2 flashes every 5 seconds: battery charged from 33% ÷ 66%
- 3 flashes every 5 seconds: battery charged from 66% ÷ 99%
The flashing stops when charging is complete; once charging is complete, remove the cable and
reinsert the USB protection cap into its seat.
Warning: if during the charging phase the light flashes constantly every 0.5 seconds, immediately
disconnect the battery charging cable and proceed to check the battery connections with the
metal connectors and the integrity/presence status of the battery.
(fig. 3)
It is suggested to position the body on the
opposite side to the hand being used (for exam-
ple for a right-handed person, position the
battery body on the left side of the spraygun).
To turn on the light, press the ON/OFF power
button; the light will gradually reach the last
intensity set, otherwise, in the case of a partially
charged battery, it will reach the maximum
value allowed by the battery charge (lower than
the one previously set).
9
EN