Create Wind Stylance Manual De Instrucciones página 10

• Mark the correct position of the holes and fix the ceiling bracket using the screws with metal
anchor or screws and washers suitable for the type of ceiling chosen.
• Check the correct installation of the bracket before hanging the fan. This plate must support the
full weight of the fan.
INSTALL ATI ON PRE PAR AT I O N
• To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 2.3 m from the floor and 50 cm from
any wall or obstruction.
• Be sure the outlet box is securely attached to
the building structure and can support the full
weight of the fan.
IN STAL LIN G THE MOU NT I NG B R ACKE T
• Check that the ceiling where you intend to mount the fan is stable and capable of safely
supporting the weight of the fan.
• Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
Wood roof
Drill the necessary holes and then secure
the mounting bracket with the wood screws
and washers to the ceiling joints.
NOTE: This fan can also be installed in a false ceiling, for this you must use fixing screws
with a spring lever (not included).
• Mark the correct position of the holes and fix the ceiling support using the screws with
metal anchors or screws and washers suitable for the type of ceiling chosen.
• Verify proper installation of the bracket before hanging the fan. The mounting bracket
must support the entire weight of the fan.
D OWNROD I N STALL AT I O N
• Choose the suspension bar that best suits your situation: it has a 15 cm and a 25 cm suspension bar.
• Remove the bar bolt, removing the pin, and pass the canopy (roof trim) and the engine canopy
through the suspension bar. Next, route the fan motor cables through the inside of the suspen-
sion bar. Tighten the suspension bar to the engine and insert the bolt and pin.
E NGL I SH
10
INSTALLATION INSTRUCTIONS
50 cm from
wall or nearest
obstruction
Concrete roof
Drill holes with an 8mm drill bit, accord-
ing to the length of the expansion screws.
Next, secure the mounting bracket to the
ceiling with the expansion screws.