Assembly And Operation; Applications; Prior To Operation - Hitachi GP 2 Manual De Instrucciones

English

ASSEMBLY AND OPERATION

APPLICATIONS

Finishing of dies for press working, die casting and moulding.
Finishing of thread cutting dies, tools and other small parts.
Internal grinding of tools and machine parts.
WARNING:

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source
requirements specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a
receptacle while the switch is in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as
short as practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired.
Contact a licensed electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause overheating, resulting in a serious
hazard.
5. Check the work site and surrounding area
Be sure that the work area has been thoroughly checked and prepared to avoid
any unsafe conditions. Review the SAFETY section of this manual.
10
To avoid the risk of serious injury, NEVER use this grinder with
abrasive wheels, cut-off wheels and/or saw blades.
WARNING:
Damaged cord must be replaced or repaired.