Descargar Imprimir esta página

JENN-AIR JGD8430 Guía De Uso Y Cuidado página 5

Cubierta a gas con ventilacion en vidrio
Ocultar thumbs Ver también para JGD8430:

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS
fuels. Properly adjusted burners will minimize
incomplete
combustion.
Exposure to these substances
can also be minimized
by properly venting the burners
to the outdoors.
IMPORTANT
NOTICE REGARDING
PET BIRDS:
Never keep pet birds in the kitchen or in rooms where
the fumes from the kitchen could reach. Birds have a
very sensitive respiratory
system. Fumes released during
an oven self-cleaning
cycle may be harmful or fatal to
birds. Fumes released due to overheated
cooking oil,
fat, margarine
and overheated
non-stick
cookware
may
be equally harmful.
Electrical Connection
Appliances
which require
electrical
power are equipped
with a three-prong
grounding
plug which must be
plugged directly into a properly
grounded
three-hole
120 volt
electrical
outlet.
Always disconnect power to appliance before servicing.
The three-prong
grounding
plug offers protection
against shock hazards. DO NOT CUT OR REMOVE
THE THIRD GROUNDING
PRONG FROM THE
POWER CORD PLUG.
If an ungrounded,
two-hole
or other type electrical
outlet is encountered,
it is the personal
responsibility
of the appliance
owner to have the outlet replaced
with a properly grounded
three-hole
electrical
outlet.
Ducting Information
Jenn-Air's ventilation
system is designed to capture
both cooking fumes and smoke from the cooktop
surface. If the system does not, these are some ducting
installation
situations to check:
• 6" diameter round or 3 W' x 10" rectangular
ducting
should be used for duct lengths 10'-60'.
Note:
Use 5" diameter round ducting if the duct
length is 10' or less.
• No more than three 90 ° elbows should be used.
Distance between elbows should be at least 18".
• Recommended
Jenn-Air wall cap MUSTbe
used.
Make sure damper moves freely when ventilation
system is operating.
• There should be a minimum
clearance of 6" for
cooktop installed near a side wall.
• There should be a minimum
clearance of 12" between
the bottom of the wall cap and the ground.
If there is not an obvious improper
installation, there
may be a concealed problem such as a pinched joint,
obstruction
in the pipe, etc. Installation
is the responsi-
bility of the installer and questions should be addressed
first by the installer. The installer should very carefully
check the ducting installation
instructions.
• Use the Flow Tester Card provided with
your appliance to check the air flow.
FLOW
TESTER
t
Save These Instructions for Future Reference
4

Publicidad

loading