Publicidad
Idiomas disponibles
Idiomas disponibles
4
LOWER CHUTE (See Fig. 4A or 4B)
1. Identify the lower chute for your model.
NOTE: Lower chute for 46 inch models are stamped with
part #405455. Lower chute for 48 inch models are not
stamped with part number.
2. Raise and hold deflector shield in upright position.
3. Place slot in lower chute over mounting tab on mower
and position lower chute over mower opening as shown.
4. Hook rear latch into flange hole on back of mower.
5. Hook front latch into tab hole on front of mower.
CAUTION: Do not remove deflector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
46 INCH MODELS
DEFLECTOR SHIELD
HINGE BRACKET
DEFLECTOR SHIELD
48 INCH MODELS
DEFLECTOR
SHIELD
TAB
MOUNTING
FRONT LATCH
REAR LATCH
FIG. 4A
OPTIONAL
FRONT
GAUGE
WHEEL
FRONT
LATCH
REAR LATCH
FIG. 4B
5
UPPER CHUTE (See Figs. 5A and 5B)
1. Lower mower to its lowest cutting position.
2. Assemble and install latch pin hardware into appropriate
hole as shown in figure 5A.
3. Assemble upper chute by inserting curved end into
hole in back of cover.
TIP: Holding upper chute as shown and twisting while
installing in cover will help keep the rubber seal in place.
NOTE: Handle carefully so as not to damage full bag
indicator.
SCREW
46 INCH MODELS
48 INCH MODELS
TAB
3. Push in and turn upper chute until it is in line with lower
chute.
4. Align the bosses on lower chute with alignment slots
on upper chute and slide together.
5. Secure with rubber latch by hooking hole in latch over
latch pin.
COVER
6
LEVEL MOWER DECK
Ensure deck is properly leveled for best mower perfor-
mance. See your tractors operator's manual for instruc-
tions.
7
SPLIT SPACER
ACORN NUT
WASHER
COVER
FIG. 5A
FULL BAG
INDICATOR
HANDLE
LATCH PIN
ALIGNMENT
SLOT
BOSSES
FIG. 5B
UPPER
CHUTE
UPPER
CHUTE
RUBBER
LATCH
LOWER
CHUTE
Publicidad
