Publicidad
Idiomas disponibles
Idiomas disponibles
Device-specific additional instructions for nailer
4
Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Pull pusher 1 backwards and engage. Insert staple rod into the
magazine from above and push forward. Disengage the pusher
and push it forward
5
Adjusting drive-in depth
Mechanical adjustment of drive-in depth:
Turn adjustment knob 1 for deeper countersunk nails clockwise.
Turn anti-clockwise to lower the nails less deeply.
6
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 28927-13:2022-02 (Vibrations at driving tools).
Date: 25.01.2023
------------------------------------------
Dr. Jörg Dalhöfer, CEO
R20/35 -G645E
.
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7
Publicidad
