Publicidad
Idiomas disponibles
Idiomas disponibles
2610046815.qxp_GAX18V-30 6/16/17 7:36 AM Page 6
Plug charger cord into your standard power outlet.
With no battery pack inserted, the charger's green
indicator lights 4 and 7 will go ON. This indicates
the charger is receiving power and the charger is
ready for operation.
When you insert a battery pack 1 into
either slot 2 or 3, the corresponding
green indicator light 4 or 7 will begin to
"BLINK". This indicates that a battery
is receiving a fast charge.
NOTES:
• Only one battery can be charged at a time. The
first battery inserted is the first to get charged.
The second inserted battery will start charging
only after the first battery is fully charged.
• If both batteries are installed before connecting
the charger to power outlet, the 18V battery
charges first.
Once approximately 80% battery capacity has
been reached, the blinking of green light will slow
down, indicating that fast charging is now
complete. If battery remains in charger, the
charging process is completed in Long Life
charging mode.
The purpose of the rapidly "BLINKING" green light
is to indicate that the battery pack is fast-charging.
It does not indicate the exact point of full charge.
The light will stop blinking when battery is fully
charged.
Continuous green battery charger light
indicates that the battery is fully
charged. However, the battery pack
may be used at any time, even if the
green light is still blinking.
You can use the USB port 6 to charge various
battery-operated USB devices like mobile
phones, tablets or MP3 players.
Ensure that your external USB device can be
charged using the USB port on the charger.
Do not connect any device
that is not compatible with
5VDC, 2.1A power source to the USB port.
Charging of non-compatible devices may create a
risk of charger malfunction.
6
Charging Battery Pack
the charging process. Charging (Fast or long Life
Charging Mode) is only possible when the
temperature range of the battery pack is between
32°F (0°C) and 113°F (45°C).
As soon as the battery pack reaches the correct
temperature range, the battery charger will
automatically switch to fast charging.
pack is contaminated, the battery pack itself may
be defective, or battery may be wrong type for this
charger.
• Check to see if the battery is compatible with
charger.
• If applicable, insert another compatible battery
pack into charger to verify charger is working
properly.
• Clean the contacts of the charger or battery
pack (e. g. by using a cotton swab and alcohol
on battery and charger terminals or inserting
and removing the battery several times) or
replace the battery pack, as required.
When the battery pack is fully charged, unplug the
charger (unless you're charging another battery
pack) and slip the battery pack back into the tool.
Charging USB Devices
Connect USB cable 9 of your device to USB port 6
to charge.
NOTES:
- The USB port provides power even if a battery
pack is currently being charged in the slot 2 or 3.
- The USB port remains active even when nothing
is connected to it.
A steady red indicator light means
that the battery pack is outside the
proper temperature ranges (too hot or
too cold) so the charger will not begin
If the red indicator light is
"BLINKING", the battery pack cannot
accept a charge. This may be due to
the contacts on the charger or battery
Publicidad
