Publicidad
Idiomas disponibles
Idiomas disponibles
5. Problems and solutions
Problems
No longer works or
very slowly
Works alone
Moisture blown out of
tool
The tool runs at normal
speed but loses power
SODISE 85 Route de Pont Gwin - 29510 Briec - FRANCE
Possible causes
1. Presence of dust in the
engine block
2. Air pressure too low
3. Lack of oil
4. Worn ball bearings
1. Trigger mechanism
2. The valve
stem cannot be
removed
3. Deformed or dirty ball
4. Damaged spring
1. Presence of water in the tank
2. Presence of water in the air
pipe
1. Lack of lubrication
2. Regulator in wrong position
3. Low pressure
4. Worn impact mechanism
SODISE NIU 06974 V.2.2
Corrective action
1. Introduce diesel oil through the air inlet
to clean the engine block, and then
add
recommended
lubricate it (SAE#10)
2. Check the air compressor used and
adjust the compressor regulator.
3. Lubricate with engine (SAE#10) or
sewing machine oil.
4. Replace ball bearings
Replace defective parts
1. Dry the tank, oil the tool and run until
the presence of water is no longer
detected. Oil the tool again
operate for 1-2 seconds.
2. Install a filter to retain the water.
NOTE: for the filter to be effective, the air
used must be cold. Install the filter as far
away from the compressor as possible.
1. Dry the tank, oil the tool and run until
the presence of water is no longer
detected. Oil the tool again
operate.
2. Install a filter to retain water
engine
oil
to
and
and
24
Publicidad
