Publicidad
Idiomas disponibles
Idiomas disponibles
LVAD2
8
Access Panel
CAUTION For applications where children are present or for applications subject to vandalism,
order security screw option S45-2880.
Make all connections before installing access panel.
Thumb screw installation is shown. Similiar installation
for vandal-resistant screws. For cam locks, refer to the
separate installation guide provided.
Attach the access panel
brackets to the wall (refer to
A
rough-in drawing) by installing
the #10 top screws (supplied by
installer) into the slotted holes.
Do not install the #10 bottom
screws at this time.
Insert the #10 thumb screws
B
into front bowl apron. Thumb
screw in the vertical position
is closed. Thumb screw in the
horizontal position is open.
Hang access panel onto
mounting brackets attached
to the wall on the left and
C
right sides. Rotate panel up
and check fitup between
thumb screws and panel slots.
Route the access panel down
and adjust the access panel
brackets if necessary.
After access panel brackets
D
are properly adjusted, install
the #10 bottom screws to
secure the brackets in place.
E
Attach P-trap to drain adapter
and waste outlet.
F
Rotate access panel up and
secure by rotating thumb
screws to the closed position.
To open access panel, rotate
G
thumb screw, slightly push
panel up and swing access
panel down. Do not remove
thumb screws.
12
#10
Thumb
Screw
#10 Top
Screw
6/1/2022
Shown in closed position.
Rotate 90° to open.
#10 Bottom
Screw
Bradley • 215-1850 Rev. G: ECO 22-08-019
Installation
Publicidad
