KRESS KAC105 Manual Del Usuario página 10

machine.
STORAGE
1. Remove the battery pack from the trimmer before storage.
2. If the machine becomes wet in the rain during operation, the machine and the battery should be dried
before storing or charging. Remove the battery and reinsert it if the machine fails to turn on.
3. Store the trimmer and the battery in a dry and secure place that is inaccessible to children and other
unauthorized people.
Remove the cutting attachment if no use for a long time.
4. Store the battery only within a temperature range between 41
not leave the battery in the car in summer time.
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
TRIMMER
Problems
Battery indicator LED
flashing
Red error LED flashing
EN
The product does not start
Trimmer runs intermittently
Excessive vibrations/ noise.
TECHNICAL DATA
Type Designation: KAC105
Cutting speed
Cutting diameter
10
Possible Causes
Low battery voltage.
Overload.
Temperature issue.
The Throttle Trigger and the
start/stop button are pressed
at the same time.
Other problems
Deris in the battery
connectors.
Other problems
The battery is not fully
inserted to the machine.
Potential electrical issue.
Line balance issue.
Cutting attachment issue.
Machine defective.
o o o o
F (5 C) and 77 F (25 C). As an example, do
Corrective Action
Charge the battery.
The cutting attachment is jammed.
Deactivate the product. Remove the
battery. Clean the cutting attachment from
unwanted materials.
Let the product cool down.
Release Throttle Trigger. Perform the
starting sequence again.
Contact Service Agent
Clean the battery connectors with
compressed air or a soft brush.
Contact Service Agent.
Insert the battery fully.
Contact Service Agent.
Rewind the line.
Replace cutting attachment.
Contact Service Agent.
KAC105
4500 / 5900 rpm
42cm