KRESS KAC105 Manual Del Usuario página 8

extremely dangerous. Use only the cutting line
recommended in this manual, in combination
with the recommended debris guard.
WARNING! A damaged or loose cutting
attachment head may vibrate, crack, break
or come off the trimmer, which may result in
serious or fatal injury or property damage. Make
sure the trimmer head are properly and securely
tightened and in good condition before starting
work.
B
1. Insert the torx key into the hole and rotate the
trimmer head until it stops in a locked position.
EN
2. Then, rotate clockwise to remove it, and
counterclockwise to assemble it. (See Fig. A1)
Winding the line (See Fig. C1, C2, C3)
1. Rotate the spool cap until the two triangle icons
are aligned. (See Fig. C1)
C1
8
C2
C3
2. Insert the replacement line through the eyelet
(Line In) and feed it out through the other eyelet.
Ensure both ends of the line are even on each
side of the trimmer head (recommended
6.5 ft (2 m) and cut the line. (See Fig. C2)
3. Turn the dial clockwise to wind the line around
the spool until about 6''(16 cm) remains on either
side. (See Fig. C3)
Lubricating the gearbox (See Fig. D1, D2)
1. Remove the screw on the gearbox.
2. If there is no bevel gear grease on the end of the
screw, squeeze 5 g of the gear grease (SHELL
Gadus S2 V220 1) into the gear housing.
3. Refit and tighten the screw firmly.
4. Install the battery and run the trimmer for 1
minute to ensure the gear is evenly lubricated.
2 m
(6.5 ft)
2 m
(6.5 ft)