KRESS KAC105 Manual Del Usuario página 7

WARNING – Beware of thrown
objects
Do not use metal blades
WARNING – Disconnect battery
before maintenance
Wear hand protection
Li-Ion battery This product
has been marked with a
symbol relating to 'separate
collection' for all battery packs
and battery pack. It will then
be recycled or dismantled in
order to reduce the impact
on the environment. Battery
packs can be hazardous for
the environment and for human
health since they contain
hazardous substances.
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Do not expose to moisture.
Trimming
Waste electrical products
must not be disposed of with
household waste. Please
recycle where facilities
exist. Check with your local
authorities or retailer for
recycling advice.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the cutting head (See Fig. A1)
1. Fit the cutting head. Insert the torx key
into the hole and rotate the trimmer head
counterclockwise until it stops in a locked
position.
A1
Assembling the debris guard (See Fig. A2)
A2
1. Install the correct Debris Guard for the trimmer
head.
2. Secure the guard in place using the screw and
torx key.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance on the
trimmer.
Replacing the trimmer head (See Fig. B)
WARNING! Use of wire or metal-reinforced
line is not authorized and could be
EN
7