KRESS KAC105 Manual Del Usuario página 9

D1
D2
Assembling and disassembling the Power
head attachment. (See Fig. E1, E2, E3)
1. Remove the protective cap from the end of the
attachment shaft.
2. To assemble, align the triangle icon on the button
with the arrow label on the attachment shaft.
3. Push the shafts together until you hear a "click".
The edge of the arrow label should be close to
the shaft connection housing.(Note: If the trimmer
shaft cannot be fully installed into the power hear,
rotate the trimmer head a little until it is possible
to insert the shaft fully.)
4. Finish the assembly by tightening the knob
clockwise.
5. To disassemble, loosen the knob, turn counter
clockwise, then press the release button and
pull the shafts apart. Replace the protective cap
on the attachment shaft to ensure that dust and
debris do not get into the shaft.
E1
E2
2
E3
3
2
CLEANING
1. Switch off the trimmer and remove the battery.
1. Do not use aggressive detergents or solvents.
Clean the machine after use with a damp cloth
dipped in mild detergent.
2. Keep battery connection free of dirt and debris,
and clean with a soft and dry brush or cloth.
3. Do not spray water onto the motor and electrical
components.
4. Do not use pressure washer to clean your
3
1
EN
1
9