Panasonic PanaSync SL95 Manual De Instrucciones página 8

Ocultar thumbs Ver también para PanaSync SL95:

Idiomas disponibles

♦ Connecting Procedures

Turn off your computer.

Connect the signal and power connectors as shown below.

Turn the monitor on, then turn on the computer.

A. IBM PS / 2 or compatible models

Then connect the other end of the supplied 15 pin mini D-Sub cable to the computer's corresponding

15 pin mini D-Sub video connector.

Then connect the other end of the AC power cord to a grounded power outlet.

B. Apple computer

monitor's Port A,

Then connect the other end of the supplied 15 pin mini

D-Sub cable to an optional UNIMAC-82D MAC adapter and

the other end of the MAC adapter to the computer's

corresponding 15 pin mini D-Sub video connector.

First connect the supplied AC power cord to the CEE22

connector on the rear of the monitor. Then connect the

other end of the AC power cord to a grounded power

outlet.

Panasonic MAC adapter

If you need an adapter and one is not provided by your dealer, call 1-800 PANASVS (1-800-726-2797).

— Caution:--——

To prevent the cable from coming loose, the cable connectors must be securely fastened with screws.

Then connect the other end of the BNC cable, usually a 15 pin mini D-Sub connector, to the computer's

corresponding 15 pin mini D-Sub video connector.

(|) First connect the supplied AC power cord to the CEE22 connector on the rear of the monitor.

Then connect the other end of the AC power cord to a grounded power outlet.

♦ Connection of AC Power Supply

If the AC power supply voltage is in the range 100 V to 240 V, either 50 Hz or 60 Hz frequency can be used.

There is no AC 100 V / 240 V selector switch as selection is automatic.

— Precaution:-

• In order to use the display unit safely, use a power cord that is properly grounded.

• AC plug cords for the following countries must be used as follows:

U.S.A.UL

Canada.CSA

For use in other countries, make sure that the AC cord meets the safety standards of each country.

Tx-d9s45mb