Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
glass. This accumulated heat, which does
not pass to the glass, is evacuated from the
bottom of the hpb, so it is very important to
follow the installation instructions so that
the hob can be ventilated.
If you install an induction hob on top of a
drawer, and leave the minimum distance
and proper ventilation, the drawer or the
utensils in it may get hot. This is not a fault.
Do not store flammable objects
such as napkins in the drawer
at the bottom of the hob.
Before you install the hob,
make sure that
• The work surface is square and level,
and no structural members interfere
with space requirements
• The work surface is made of a heat-
resistant material
• If the hob is installed above an oven, the
oven has a built-in cooling fan
• The installation will comply with all
clearance requirements and applicable
standards and regulations
• A suitable isolating switch providing
full disconnection from the mains
power supply is incorporated in the
permanent
wiring,
positioned to comply with the local
wiring rules and regulations
• The isolating switch must be of an
approved type and provide a 3 mm air
gap contact separation in all poles (or in
all active [phase] conductors if the local
wiring rules allow for this variation of
the requirements)
• The isolating switch will be easily
accessible to the customer with the hob
installed
• Please check local building authorities
and by-laws if in doubt regarding
installation
• Please use heat-resistant and easy-to-
clean finishes (such as ceramic tiles)
for the wall surfaces surrounding the
hob.
When you have installed the hob, make
sure that
46
Before locating the fixing brackets
The unit should be placed on a stable,
smooth surface (use the packaging). Do not
apply force onto the controls protruding
from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw
4 brackets on the bottom case of hob (see
picture) after installation. See picture 5 on
page 7.
See picture 6 on page 7.
A. Screw
B. Bracket
C. Screw hole
D. Base
mounted
and
• The power supply cable is not accessible
through cupboard doors or drawers
• There is adequate flow of fresh air from
outside the cabinetry to the base of the
hob
• If the hob is installed above a drawer or
cupboard space, a thermal protection
barrier is installed below the base of the
hob
• The isolating switch is easily accessible
by the customer
• The
induction
installed by qualified personnel or
technicians. We have professionals at
your service. Please never conduct the
operation by yourself.
• The hob will not be installed directly
above a dishwasher, fridge, freezer,
washing machine or clothes dryer,
as the humidity may damage the hob
electronics
• The induction hotplate shall be installed
such that better heat radiation can be
ensured to enhance its reliability.
• The wall and induced heating zone
above the table surface shall withstand
heat.
• To avoid any damage, the sandwich
layer and adhesive must be resistant to
heat.
This hob must be connected to
hotplate
must
be
Publicidad
