Publicidad
Idiomas disponibles
Idiomas disponibles
blade, taking into account that the direction of movement is from right to left
as seen from the front of the machine.
•
Lower the blade guard so that it lightly touches the piece of wood to be
processed and fasten it in this way by tightening its knob.
•
Press the "I" button on the ON/OFF switch.
Pressing down the piece of wood, move it towards the blade along the guide
•
at a steady, slow pace.
•
After finishing the treatment, turn off the machine by pressing the "O" button
on the ON/OFF switch.
Planning method:
•
Determine which wider surface of the wooden piece is the flatter one.
Pull the wood with the flatter surface through the plane as often as needed
•
until the surface is smooth.
•
Hold the side to be processed firmly against the guide (at an angle of 90
the edge) and pull it through the plane many times until the side surface is
even, smooth.
•
In this way, you will obtain 2 processed sides adjacent to each other at an angle
of 90
o
.
3.3.4
Thickness processing
• Lower the worktop with the adjustment knob (12) to the level appropriate to
the size of the wooden element that will be below the blade. Processing will
run from the left to the right side of the machine.
EN
o
to
Publicidad
