Publicidad
Idiomas disponibles
Idiomas disponibles
• Bearings of the input/output rollers
• Tensioner bearings and drive belt pulleys
• Gears and threaded spindles for adjusting the height of the worktop (with
dry grease)
• Worktops and input / output rollers should always be clean and free from
sticky coatings (e.g. resin)
j)
The cutting head, clamping elements, blade supports and blades must be free
of contaminants, especially sticky ones, to ensure their efficiency and proper
functioning. These elements should be cleaned with e.g. white spirit,
extraction gas or soaked in paraffin.
3.4.1 Removing the blade
Over time and after some working hours, the cutting blade needs to be
periodically sharpened or replaced. To do this, you need to:
Turn off the device and disconnect from the power source
•
Set the cutting height to zero, i.e. turn the height adjustment knob to the
•
stop when the height indicator shows "0"
Remove the guide
•
Lift the blade guard
•
Rotate the blade shaft so that the 4 Allen screws holding the blade are
•
visible - carefully unscrew them:
Rotate the blade shaft by 180
•
the above operation.
IMPORTANT: Always sharpen/replace the blades in pairs
EN
and remove the next blade by repeating
o
Publicidad
