DeWalt DCS355 Manual De Instrucciones página 12

3.Firmly press t hebase with thesanding sheet attached against a
flatsurface andbriefly switch t hetool o n. T his provides forgood
adhesion between theplaten a ndthesanding sheet a ndalso
helps t oprevent premature wear.
4.When thetip ofthesanding sheet b ecomes worn, d etach t he
sheet from theplaten, rotate a ndreapply.
ATTACHING ACCESSORIES USING
THE UNIVERSAL
ADAPTER (FIG. 7)
Non-DEWALT accessories can be
attached using the universal adaptor.
1. Place the washer (M) on the tool.
2. Place accessory on to washer.
3. Tighten and secure adaptor nut (N)
using hex wrench.
i_ CAUTION: To avoid injury, do not
use any accessory for an application
where the adaptor may fail to hold the
accessory.
FIG.7
_ CAUTION: Read and follow all manufacturers' safety warnings for
any accessories used with this tool.
i_,CAUTION: To avoid injury, ensure adaptor and accessory are
securely tightened.
Attaching the Cut Guide (Fig. 8-12)
The depth/cut guide allows you to precisely FIG.8
cut material at a specified depth or height and
more accurately track a marked cut line.
1. Attach the cut guide block (F) by inserting
the tabs (O) on the guide into the
accessory side mount (E) on the main
body of the tool.
2. Secure the block to the main body with
the supplied screw (Q) and washer (S). $
Tighten with the supplied hex wrench (R). F
-Q
DEPTH GUIDE
This feature allows you to precisely cut
material at a specified depth.
1. Insert the guide arm (G) as shown in
Figure 9 into the front slot on the guide
block (F).
2. Adjust the length of the guide by pulling out or pushing inward to
achieve the desired cut depth as shown in Figure 10.
3. Secure the guide in place by turning the depth/cut adjustment
knob (P) clockwise. To release the guide, turn the depth/cut
adjustment knob counterclockwise.
FIG. 9
11