KRESS KAC800 Manual Del Usuario página 11

Batteries may enter water cycle if
disposed improperly, which can be
hazardous for ecosystem. Do not
dispose of waste batteries as unsorted
municipal waste.
OPERATION INSTRUCTIONS
Recommendations for optimal handling of
the battery
Note:
1. Your battery pack is partly charged and needs
to be fully charged before first use. To ensure full
capacity of the battery, completely charge the battery
in the battery charger before using your battery in the
power tool for the first time.
2. A battery pack will slowly lose its charge when
kept out of the charger or left in an unplugged
charger for a long time. It may need to be recharged
before use.
The CyberPack Nano can be used with a backpack,
please refer to the backpack manual for details.
When over-discharge, over-charge, over-temperature
and low-temperature faults occur while the battery
pack is being charged on the charger or used on the
machine, the user will receive a fault prompt, and the
charger or the machine will stop charging or working.
The Li-Ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
Avoid dropping the device or battery. If the device or
battery is dropped, especially on a hard surface, and
the user suspects damage, take it to a service center
for inspection.
The battery level can be detenmined from the battery
indicator light by pressing the power test button.
Before starting or after use, press the power test
button on the battery pack to check the battery
capacity.
Remarks LED light
Five green
lights are
illuminated.
Battery condition
80% ≤ Power level ≤ 100%
EN
11