Publicidad
Idiomas disponibles
Idiomas disponibles
two or three-star compartments.
– If the refrigerating appliance is
left empty for long periods, switch
off, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more
persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply
(if
connections and repairs must be
carried
out
by
technician. Do not repair or replace
any part of the appliance unless
specifically stated in the user
manual. Keep children away from
the
installation
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must
be stored out of reach of children
- risk of suffocation. The appliance
must be disconnected from the
power
supply
installation operation - risk of
electrical shock.
During installation, make sure the
appliance does not damage the
power cable - risk of fire or
electrical shock. Only activate the
appliance when the installation
has been completed.
Be careful not to damage the
floors (e.g.
any),
electrical
a
qualified
site.
After
before
any
parquet)
when
appliance. Install the appliance on
a floor or support strong enough
to take its weight and in a place
suitable for its size and use. Make
sure the appliance is not near a
heat source and that the four feet
are stable and resting on the floor,
adjusting them as required, and
check that the appliance is
perfectly level using a spirit level.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant circuit
is fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or
fixing of the appliance must be
done in accordance with the
manufacturer instructions.
It's
forbidden
refrigerator in such way that the
metal hose of gas stove, metal gas
or water pipes, or electrical wires
are in contact with the refrigerator
back wall (condenser coil).
To
guarantee
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear of
the appliance and the wall behind
the appliance should be 50 mm, to
avoid access to hot surfaces. A
reduction of this space will increase
the
Energy
product.
Please remove the power cord
from condenser hook during
installation before connecting
EN - 7
moving
the
to
place
the
adequate
consumption
of
Publicidad
