Publicidad
Idiomas disponibles
Idiomas disponibles
7. Attach the funnel of the BigBag on the dust outlet
with straps (C).
8. Make sure that the BigBag hangs equally on the
support rods.
9. Open the dust valve. Refer to
valve on page 14 .
To drain the water from the pressure
tank
Water in the pressurized air collects in the pressure
tank. It is necessary to drain the water from the pressure
tank daily.
1. Stop the product. Refer to
page 16 .
2. Put a container below the water valve (A) to collect
the water.
A
3. Open the water valve slowly.
4. Close the water valve when all the water is drained.
To adjust the suction power
Use the air flow hatch on the side of the product to
adjust the suction power. It is necessary to adjust the
suction power for example when the primary filters are
new or the suction is not satisfactory.
•
Adjust the suction power with the air flow hatch.
2272 - 001 - 14.05.2024
To operate the dust
To stop the product on
a) For less suction power, open the hatch.
b) For more suction power, close the hatch.
To turn the pinch bar
1. Remove the bolt and the clamp (A).
2. Remove the nut and the retainer (B).
3. Turn the pinch bar with a wrench.
4. Install the nut and the retainer.
5. Install the bolt and the clamp.
A
B
17
Publicidad
