Chicago Pneumatic FRL 1/2 BSP Instrucciones Del Producto página 6
Ocultar thumbs
Ver también para FRL 1/2 BSP:
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
The air input supply is installed at the port of input air flow. The output supply is connected to the port of output air-
flow.
Mounting the Wall Bracket
To mount the wall bracket, the user must follow the below steps:
1.
Insert sealing ring (1) to the module.
2.
Place wall bracket (2) in position to the module.
3.
Push coupling element (3) to the front of the module.
4.
Tighten screws (4). Use maximum tightening torque depending on the model, as follows:
• FRL 1/2": 2.5 Nm (22 in.lbs)
• FRL 3/4": 3.0 Nm (26.6 in.lbs)
• FRL 1": 3.0 Nm (26.6 in.lbs).
6
EN
© Chicago Pneumatic - 6159990240
Air Filter - Regulator - Lubricator
Publicidad
