Chicago Pneumatic FRL 1/2 BSP Instrucciones Del Producto página 8

Installation
Mounting the Gauge
To mount the gauge, the user must follow the below steps:
1. Install gauge (2) into the gauge thread of module (1).
2. Use size 14 open-end wrench to turn the gauge (2). Turn until the seal has been completely screwed onto the
thread.
3. Align manometer by turning it clockwise or counterclockwise up to ¾ of a turn. Maximum screwing- in torque:
8 Nm (71 in.lbs).
8
EN
© Chicago Pneumatic - 6159990240
Air Filter - Regulator - Lubricator