22
13.7 Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the pre-ground
coffee funnel (A6) is not blocked. If necessary, remove coffee
deposits with a brush.
13.8 Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser must not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see "7.
TURNING THE APPLIANCE OFF").
2. Open the service door
3. Extract the drip tray and the grounds container (fig. 18).
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (fig. 24).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Do not use washing up liquid to clean the infuser as it could
cause damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser by sliding it onto the in-
23
7. Once inserted, make sure the two red buttons have
8. Close the infuser door.
9. Replace the water tank.
14. DESCALING
Descale the appliance when the
es.
•
•
1. Turn the machine on.
2. Empty the water tank (A12).
3. Pour the descaler diluted with water (respecting the pro-
24
4. Wait for the
Hot water containing acid flows from the cappuccino maker.
Avoid contact with splashes of water.
5. Press the
32
ternal support and pin at the bottom, then push the PUSH
symbol fully in until it clicks into place.
Please note:
If the infuser is difficult to insert,
before insertion, adapt it to the
right size by pressing the two le-
vers shown in the figure.
snapped out.
Important!
Descaler contains acids which may irritate the skin and
eyes. It is vital to respect the manufacturer's safety warn-
ings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
You should use De'Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
portions indicated on the descaler pack) into the water
tank.
Place an empty container with a minimum capacity of 1.5
litres under the hot water spout.
and
Important! Danger of burns
button and hold it down for at least 5
seconds to confirm that you have added the solution and
light on the panel flash-
lights to come on steadily.