Publicidad
Idiomas disponibles
Idiomas disponibles
1) Load Group (or user memory)
After pressing ENTER, the interface will show the following image
Turn the FREQ wheel to select one of the memories, the unit offers a total of 12 banks to
store groups or settings, turn the GAIN/Q wheel to select one of them and press ENTER to
confirm.
2) Copy or duplicate channels
Press ENTER and the interface will show the following image
Turn the FREQ wheel to select the channel to duplicate or copy, turn the GAIN/Q wheel to
select between input (A,B,C,D) or output (1 to 8) (depending on model) press ENTER to
confirm the selection and Turn the GAIN/Q wheel again to select the destination channel,
press ENTER again to confirm copy.
2. Save Pro saved data
Once you have the unit configured, you can save said configuration within the unit. Press
the ENTER key and turn the FREQ wheel to select a bank (User1,2, etc.) to store the
session. Press ENTER again to confirm the save.
3. ID (device number) configuration
Set the machine identification number.
Press ENTER to go to the settings page. Rotate the FREQ/Gain/Q value to adjust the
device number value, you can toggle between 1 to 250, press ENTER again to confirm.
4.Password
You can change the password, the default is 1111, to one you can remember, so that no one
can tamper with the unit without your supervision.
www.audibax.com
ADP 24 DSP / ADP 36 DSP / ADP 48 DSP
Select and Load
1:
USER 1
Copy from:InputA
to:InputC
SYSTEM SETUP MENU
2. Save Pro
SYSTEM SETUP MENU
3. Device ID Setup
SYSTEM SETUP MENU
4. Password
10
Publicidad
