Publicidad
Idiomas disponibles
Idiomas disponibles
Turn FREQ to select Automatic and click Enter to obtain IP automatically, if your unit is
connected to a router with CAT-5/6 cabling and RJ-45 connector
Turn the FREQ wheel and select Manual and press ENTER to enter manual IP
configuration mode.
Turn the FREQ wheel to select network segments (0 to 254) per box, turn the GAIN/Q
wheel to select a value per box, no need to fill in anything else, if you assign an IP within
the range of your router, the software will find the unit with the assigned IP.
9. System information
Press Enter again to display the current device chip ID as follows:
BASIC CONNECTION OPERATIONS
Introduction:
1. RS232: Please use the proper cable to connect, connect it correctly when the indicator
lights up and then you can control it by PC software.
2. Use a USB 2.0 cable, with a type A connector for your PC and a type B connector at the
other end for the unit.
3. WiFi: Open the device to search for MhLink-xxxx. Enter the password "12345678" to
connect.
4. Connect an RJ45 Cable to the unit in said port, you can also connect it directly to your
PC as long as your PC interface is in the same NETWORK range as the unit.
Example: if the unit has an IP 192.168.1.128, your computer must have a fixed IP assigned
within the same range, in this case, configure your network card with the following data
i.p. 192.168.1.100
netmask 255.255.255.0
gateway 192.168.1.1
In this way, since the unit is within the same network range as your PC, you can access
said control.
Yeah. You connect the unit to a router and it has the "Automatic" assignment mode, you
can see the IP assigned by the router in the information interface, with your PC
connected to the same router, you will be able to access the unit without problem.
www.audibax.com
ADP 24 DSP / ADP 36 DSP / ADP 48 DSP
<Manual IP config>
0. 0. 0. 0
Audibax Dsp Control
V1.0.0-20200917
Audibax Dsp Control
Chip ID 39ffd7-200917
12
Publicidad
