DeWalt DCF620 Traducido De Las Instrucciones Originales página 21

only with water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Nosecone Maintenance (Fig. A, C)
If the nose cone 4 becomes hard to turn it may be
contaminated with drywall dust.
1. Remove nose cone from tool.
2. Rinse thoroughly with warm water while rotating both screw
depth adjustment collar 2
or solvents.
3. Dry the nosecone completely before reattaching to tool.
Optional Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT recommended accessories should be used
e
with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long-life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a local
recycling station. The collected battery packs will be recycled or
disposed of properly.
and locking collar 3 . Never use oil
EngLIsh
21