Husqvarna 122LK Manual Del Usuario página 10

1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
WARNING:
follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
10
Do not mix fuel for more
Obey the procedure that
Make sure that there is
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to
To examine before start
1. Make sure that the product has no missing,
damaged, loose or worn parts.
2. Make sure that nuts, screws and bolts are tightened.
3. Make sure that the air filter is not clogged.
4. Make sure that the safety devices on the product
operate correctly and are not damaged.
5. Make sure that the product has no fuel leaks.
To start a cold engine
1. Push the air purge bulb 10 times.
2. Set the choke control in the choke position.
3. Hold the body of the product on the ground with your
left hand.
CAUTION:
product.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance. Then pull the starter
rope handle quickly and with force until the engine
starts or tries to start.
Do not step on the
2554 - 001 - 19.07.2024