Husqvarna 122LK Manual Del Usuario página 6

• Keep first aid equipment close at hand.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. Refer to
Maintenance schedule on page 11 .
• If the safety devices are damaged or do not operate
correctly, speak to your Husqvarna servicing dealer.
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
2. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when you
release it.
6
Read the warning
A
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING:
when the throttle trigger is in the idle
position, then the carburetor idle speed
must be adjusted. Refer to
idle speed on page 12 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
Muffler
• Do not use an engine with a damaged muffler. A
damaged muffler increases the noise level and the
risk of fire. Keep a fire extinguisher near.
• Examine regularly that the muffler is attached to the
product.
• Do not touch the engine or the muffler when then
engine is on. Do not touch the engine or the muffler
for a while after the engine stops. Hot surfaces can
cause injuries.
• A hot muffler can cause a fire. Be careful, if you use
the product near flammable liquids or fumes.
• Do not touch the parts in the muffler, if the muffler is
damaged. The parts can contain some carcinogenic
chemicals.
If the blades move
To adjust the
2554 - 001 - 19.07.2024