Publicidad
Idiomas disponibles
Idiomas disponibles
. Preparing the ice cube maker
Check the ice cube maker for transport damage.
Place the ice cube maker onto a level, non-slip and heat-resistant surface.
Before using the ice cube maker for the first time, wait 2 hours after you have set
it up. Leave the water tank cover open for at least 2 hours.
Before using the appliance for the first time, clean the accessories (ice cube
basket, ice scoop) and the appliance with a soft, slightly damp cloth. Allow
everything to dry thoroughly.
Carry out the cleaning function ('8. Cleaning the ice cube maker' on page 126).
For hygiene reasons, do not use the ice cubes from the first preparation.
The appliance is now ready for use.
The appliance is driven by an electric motor. This can lead to a slight
smell during initial operation. This smell is normal and is not a sign of a
malfunctioning appliance. Ensure that there is adequate ventilation.
. Using the ice cube maker
NOTICE!
Risk of damage!
The use of additives such as syrup or colourants can
damage the water sensor and the pump.
Only use clean drinking water with no additives.
Remove the ice cube basket from the appliance.
Fill the drinking water tank up to the MAX mark. Do not fill above the mark.
Reinsert the ice cube basket.
Close the ice container flap.
Connect the appliance to a properly installed socket.
Press the
button to start the ice cube production.
The animated symbol
is shown in the digital display.
Press the
button to select the ice cube size. The ice cube size is shown in
the display panel with the symbols
You will hear when the ice cubes are released from the freezer fingers and pushed
into the ice cube basket by the ice cube slider.
The production process starts again.
Regularly check the water level in the drinking water tank. If the level is too low,
the
symbol lights up and ice production is paused.
Refill water only up to the MAX mark.
indicates that ice cubes are being made. The elapsed time
or
.
DE
FR
NL
ES
IT
EN
125
Publicidad
