Publicidad
Idiomas disponibles
Idiomas disponibles
.. Automatic cleaning
Fill the drinking water tank up to the MAX mark. Do not fill above the mark.
In standby mode, press the
The cleaning symbol
During the cleaning process, water is continuously pumped from the lower water
tank into the upper compartment in five passes. The water flows back into the low-
er water tank through the overflow opening. If the sensor detects that there is not
enough water in the lower tank, the cleaning process is paused and the
is displayed.
...
Descaling
Prevent limescale forming on the appliance parts because the function is impaired
by lime deposits:
After every 100 hours of operation, add citric acid and warm water to the drink-
ing water tank and leave the solution to soak for 2 hours.
Run the cleaning function 5 times.
Empty the water tank as described above and then carry out a cleaning cycle
with fresh water. To do this, fill the water tank up to the MAX mark.
Empty the water tank again after the rinse cycle and clean the appliance as de-
scribed above.
. Prolonged non-use/transport
If the appliance will not be used for a long period of time:
– pull the mains plug out of the socket
– defrost the appliance
– clean it
– drain any residual water from the appliance
– leave the appliance open to prevent unpleasant odours forming and mould
growing
Store the completely dry appliance in a dry, dust- and frost-free location out of
direct sunlight.
To avoid damaging the product during transport, we recommend that you use
the original packaging.
button to start automatic cleaning.
lights up.
DE
FR
NL
ES
symbol
IT
EN
129
Publicidad
