Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
FUNCTION
FOWER
FLAME
TIMER
ICON
The POWER button supplies power to all the
functions of the fireplace. Pressing the POWER
button again will put the fireplace in standby mode.
This will turn off all functions at once but will hold
the settings in the memory. By pressing the Power
button again the unit will turn on at the same
settings.
With the power on press and hold the Power button
on the control panel for 10 seconds to disable or
re-enable the heater function. Once disabled or re-
enabled the emberbed lights will flash multiple times.
There are 5 brightness levels that can be selected
and OFF (00) setting.
Settings F5 - F1 decrease in brightness.
Pressing the timer button will cycle through the timer
settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H,
7H, 8H, 9H and 00 (OFF).
To cancel the timer once it has been set, press the
TIMER button twice and the display will flash 00 to
show the timer has been canceled.
CONTROL PANEL LOCATION
DESCRIPTION
14
Remote Control
Publicidad
