The power adaptor continues to draw a
small amount of electricity, even without the
radio being operated, as long as the power
adaptor is connected to the power supply. To
completely switch off the power adaptor, it
must be disconnected from the mains network.
Do not subject the product to physical shock or
strong vibrations.
If smoke or unusual sounds are observed,
immediately unplug the power adaptor from
the power supply.
The power adaptor shall not be covered.
Disconnect the power adaptor from the power
supply when the product is not in use and
before cleaning.
Let the product dry completely before
connecting it to the mains supply and before
storage. Allow the product to cool down
completely before storage.
NOTE: This product is equipped with rubber
feet to protect delicate surfaces. It cannot be
ruled out that furniture care agents will attack
or damage the rubber feet.
Start-up
Requirements for the set-up
location
For the safe and trouble-free operation of the
product, the set-up location must fulfil the following
requirements:
When setting up the product, place it on a firm,
flat and horizontal surface. Use the fold-out
foot
.
[
]
The surfaces of some items of furniture might
contain components that can soften the rubber
feet of the product. If necessary, place a mat
under the product's rubber feet.
Set up or mount the product in such a way
that the provided ventilation openings and the
loudspeaker
are not covered.
[
]
Do not operate the product in a hot, wet or
extremely damp environment or in the vicinity
of flammable materials.
The mounting location must be selected so that
the product is not exposed to vapours. Do not
install the product directly over a hotplate.
28 GB/IE
Installation under a wall
cupboard
Using the supplied mounting plate
install the product e.g. under a wall cupboard.
Proceed as follows to mount the product:
Slide the mounting plate
remove it from the product.
Find a suitable installation location for the
product (see "Requirements for the set-up
location").
Hold the mounting plate
installation location. Ensure that the front edge
of the mounting plate is approx. 3.3 cm behind
the front of the cupboard so that the product is
flush with the cupboard after installation. The
side edges of the mounting plate
spaced approx. 5.8 cm away from adjacent
cabinets or walls.
Mark the 4 mounting points with a pencil.
Using a pin or nail, make a small depression at
the respective marking points. In hardwoods,
drill a hole with a depth of approx. 5 mm in the
markings using a Ø 2.5 mm wood drill bit. Be
careful not to drill the hole all the way through.
If required, place the supplied spacers
between the cupboard and the mounting plate.
If you are using the spacers
the long mounting screws
Screw the mounting plate
mounting screws (
[
With the top of the product against the
mounting plate
, push the product back until
[
]
it clicks into place.
3.3 cm
5.8 cm
, you can
[
]
to the rear and
[
]
under the
[
]
must be
[
]
[
]
, you will need
[
]
.
[
]
tight using the
[
]
or
) .
]
[
]