Adler europe AD 2832 Manual De Usuario página 4

only by authorized service centers. Improper repair may cause serious danger
to the user.
10. Place the appliance on a cool stable, level surface, away from hot kitchen
appliances such as electric stove, gas burner, etc....
11. Do not use the device near flammable materials.
12. The power cord must not hang over the edge of the table or touch hot
surfaces.
13. Do not leave the device or the power supply to the outlet unattended.
14. To provide additional protection, it is advisable to install in the electrical
circuit, a residual current device (RCD) with a rated residual current of not
more than 30 mA. In this regard, please consult an electrical specialist.
15.When the appliance is used in the bathroom, remove the plug from
the outlet after using it, as the proximity of water poses a danger even when the
appliance is turned off.
16. Do not allow the device or power supply to get wet. If the device falls into
water, immediately pull the plug or power adapter from the power outlet. Do
not put your hands in the water while the device is plugged in. Before using it
again, it must be checked by a qualified electrician.
17. Do not grab the device or power adapter with wet hands.
18. Turn off the device each time you put it away.
19. Do not leave the device or power adapter plugged into an outlet
unattended.
20. Do not use the device near water e.g.: in the shower, in the bathtub
or over a sink with water.
21. If the device uses a power adapter, do not cover it, as this could lead to a
dangerous rise in temperature and damage to the device. Always, first insert
the plug into the power socket on the device and then the power adapter into
the power socket.
22.The cutting blades are very sharp. Be careful when assembling,
disassembling and cleaning Do not touch the moving parts of the blades while
the device is operating!
23.Do not use the device for more than 10 minutes. After this time, turn off the
device for about 5 minutes. DO NOT recharge the battery for longer than 48
HOURS - this may cause irreversible damage to the battery.
24.The charging process should be carried out at temperatures between 5 and
35 degrees Celsius.
4