Publicidad
Idiomas disponibles
Idiomas disponibles
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
WARNING! Risk of injury from dan-
gerous, moving parts! Be careful with the
line cutter. It can cause serious lacerations.
• After each use, remove all grass and
dirt from the protective cover and the
cutting unit.
Maintenance
Replacing the spool
The correct winding direction of the spool
(18) is specified in the spool cap (20) and
on the spool. The arrows on the spool cov-
er (31) indicate the direction of rotation of
the motor.
Procedure(Fig. B)
1. Remove the battery (6) from the
device.
2. the spool cap (20) by simultaneously
pressing the two releases (30) on the
spool cap.
3. Remove the spool cover (31) and take
out the old spool.
4. Insert the new spool into the spool cap
(20). The side of the spool (18), on
which the rotation direction is indicated
by arrows, must be visible after inser-
tion.
5. Insert the end of the line through the
line outlet loop (19).
6. Put the spool cover (31) back on the
spool cap. Make sure that the releases
(30) on the cover fit precisely into the
recesses on the spool cap. You will
hear them snap into place.
7. Pull the line ends until they stick out
about 1 cm above the line cutter (32).
8. Check the line cutter.
Never use the device without a line cutter
or with a defective line cutter. Contact the
service centre if the line cutter is damaged.
Winding up spare line
1. Thread an end of the spare line
through the opening of the spool (18).
2. Wind the line in the winding direction
of the spool. Pay attention to the ar-
rows on the top of the spool.
Storage
Always store the device:
• clean
• dry
• protected against dust
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
Do not lie the device down on the protect-
ive cover. It is best to hang it on the upper
handle so that the protective cover does
not touch any other objects. There is a risk
that the protective cover will become de-
formed, thus changing the dimensions and
safety characteristics.
GB
MT
37
Publicidad
