Hisense H25MOBS1HC Instrucciones Para El Uso página 10

OPERATION INSTRUCTION
BEFORE COOKING
TIME/WEIGHT KNOB
PAUSE/CANCEL
AUTO REMINDER
CLOCK SETTING
MICROWAVE COOKING
10
The LED flashes 3 times when plugged in power supply.
Then it flashes "1:00", and it is the default standby status.
You can increase or decrease cooking time or weight during
operation by turning Time/Weight knob.
At the initial or input stage: press once to cancel input
programs and resume initial stage. During cooking: press
once to stop oven operation, press twice to cancel cooking
programs. When you reset cooking programs, should press
this button to cancel all the former settings.
When your preset cooking procedure have finished, and
three beeps sound will be heard to prompt you to take out
food.
If you do not press Pause/Cancel button once or open the
door, the beep will be sounded at an interval of 3 minutes.
In standby mode, hold Clock/Defrost/Temp button 3
seconds to enter the clock setting status.
The display shows the clock, in which the hour position is
flashing, which means the clock input status.
At this time, rotate Time/Weight Knob, input hours,
reverse rotation is 23-22-0 hours cycle; forward rotation
is: 0-1-23 hours, cycle; after setting the hour, press
Clock/Defrost/Temp again, enter minute setting.
Rotate the Time/Weight knob, enter the minutes, and
reverse the rotation: 59-58-00 minutes, cycle; Forward
rotation: 00-01-59 minutes, cycle; after setting the clock
time.
The last Press Clock/Defrost/Temp button again to confirm
(or delay for 60 seconds).
The clock will enter the running state. At this time, ":"
flashes and displays once per second.
This function is for cooking and heating food. Pressing
Micro Power button, LED will cycle to show 100P — 80P —
60P — 40P — 20P.