Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Welding current (A).
20 – 40
41 – 60
61 – 90
91 – 130
131 – 160
161 – 200 (*)
(*) Only VULCANO 202.
(1)
•
Press the knob
HOT START
➢
for an instant to start welding. It can be adjusted between 0-100% by turning the
(1)
knob
. The factory default is 0%.
ARC FORCE
➢
to the material to be welded, preventing the arc from going out when contact occurs,
through the drops themselves, between the electrode and the molten pool. The
intensity of this function can be adjusted between 0-100%, turning the knob
The factory default is 0%.
(1)
•
Press the knob
and proceed as explained in the previous section 8.2. As in the
intensity increases, the thickness of the material to be welded will increase
you can consult the following table:
Welding current (A).
20 – 55
56 – 65
66 – 100
101 – 135
135 – 160
161 – 200 (*)
(*) Only VULCANO 202.
•
When you press the knob
will appear on the display. This device allows reducing the voltage of the no-load voltage, to
avoid electrical shocks, potentially fatal, to the operator. It is recommended to select the
TIG
position for the
value of 70V.), in the
•
MMA
If during the
on the screen, it means that the
protection has started to act, as described in section 5 of this manual.
material thickness (mm.)
1,5
2,5
3,2
6,0
16,0
25,0
again to select other menu functions
, facilitates the striking of the electric arc by an extra increase in power
, facilitates the transfer of drops of molten material from the electrode
TIG
again for
welding, selecting the
material thickness (mm.)
1,5
2,5
3,2
6,0
16,0
25,0
(1)
again, the abbreviation
welding process (to obtain a value of 30V.) and the
MMA
welding process.
TIG
or
welding process the symbol of a red thermometer
IGBT
has exceeded a temperature of 105ºC and the thermal
Ø of electrode (mm.)
(3)
:
LIFT TIG
VRD (4)
(Voltage Reduction Device)
36
1,6
2,0
2,5
3,2
4,0
5,0
(1)
(3)
process in the menu
MMA
process, as the
(6)
. As a guide,
ON
OFF
position (for a
(8)
appears
.
Publicidad
