Beurer IPL 10000+ Guía Rápida página 4

4
Switch the mains switch on the rear
of the base unit -> indicator lamp and
energy indicator lamp light up.
7
Press the trigger button on the appli-
cator. A bright flash appears and you
will hear a brief sound. Lift the light
surface of the cartridge o the skin
and position it on the next treatment
surface. Press the trigger button on
the application as soon as the indi-
cator lamp on the applicator lights
up green.
In the case of body hair treatment with the beurer SalonPro System, the first four sessions should be per-
formed two weeks apart. The fifth to seventh sessions inclusive can be performed four weeks apart. Any
further sessions should be performed if the hair has grown back until the desired results have been achieved.
In the case of treatment of hair on the face below the cheekbones, the first six sessions should be performed two
weeks apart. The seventh to twelfth sessions can be performed four weeks apart. Any further sessions should be
performed if the hair has grown back until the desired results have been achieved.
After application
1
Switch the mains switch on the rear
of the base unit -> device switched
o .
5
Select the desired energy level using
the energy selection buttons "-"
and "+".
8
Flash-glide function
Press and hold the trigger button =
automatic flash every 3 seconds.
2
Remove the mains cable from the
socket.
6
Position the light surface of the car-
tridge on the desired treatment
surface and make sure it is fully in
contact with the skin.
3
Clean the light surface of the car-
tridge using a dry, clean cloth.
90°