Important safety information
•
The Aduro H1 will become warm during use and therefore it should be treated with all necessary
caution.
•
Never keep easily combustible fluids such as petrol in the vicinity of the Aduro H1 – and never use
easily combustible fluids to light the fire in the Aduro H1.
•
Never empty the ash drawer when the Aduro H1 is warm. Embers may still be found in the ash
drawer for up to 24 hours after the fire has gone out. Please wait to empty the ash drawer until
you are sure that there are no embers in the ash.
•
The door should be kept closed while the Aduro H1 is in use. While lighting the fire, the door can
stand ajar for the first few minutes.
•
The pellets function is stopped if the door is opened.
•
In the event of a chimney fire: Close all the dampers on the Aduro H1 and call the fire-fighting
service.
3.1 Damper
The stove is equipped with a damper under the door, which regulates the combustion air, ie. both primary,
secondary and tertiary air supply. You must always add secondary and tertiary air, while firing the stove.
The damper allows you to adjust the Aduro H1 according to the chimney draft and the heat output you
require. The illustration shows how much air is supplied by different damper settings:
1: Fully open primary-, secondary- and
tertiary air inlet. This position can be
maintained with the Aduro key, which must
be placed in the two holes.
2: Closed primary air inlet, fully open
secondary- and tertiary air inlet.
3: Closed primary air inlet, half way closed
secondary air inlet and fully open tertiary air
inlet.
4: Closed primary- and secondary air inlet,
fully open tertiary air inlet.
5: Regulator pushed all the way in. All air
inlet closed (only used when burning wood
pellets).
3. Lighting a fire in the Aduro H1
54