Switching Off The Machine; Cleaning The Machine At The End Of The Day; Useful Tips; Maintenance - ASBER TECH Serie Manual De Instrucciones, Uso Y Mantenimiento

asberprofessional.com
6.1.8

Switching off the machine

The glass washer is switched off by pressing the ON-OFF button for 1.5 s. The machine should not be
switched off during the wash process as this will stop the tableware inside the machine from being
cleaned properly.
6.1.9

Cleaning the machine at the end of the day.

At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the glass washer must be perfectly clean and disinfected. (See figures).

6.2 Useful tips

ASBER recommends you read the useful tips listed below carefully to allow you to get the most out of
your glass washer.
6.2.1

Maintenance

Always clean the machine correctly to prolong the service life of the machine.
•
•
•
•
•
•
asberprofessional.com
49
Figure 7. Switching off the machine
CLEANING DISTRIBUTORS
Remove any waste from the machine at the end of each day.
Do not use abrasive, corrosive or acid products, or solvents and chlorine- or petrol-based de-
tergents to clean the machine.
Do not use pressurised water to clean the machine.
Only wash small items of tableware, glassware or kitchenware that has been used for human
food.
Check that the wash distributors rotate correctly everyday.
Call the technical service twice a year to have the machine serviced:
Cleaning of water filter.
o
Cleaning of limescale on the resistors.
o
Inspection of the condition of the seals.
o
Inspection of the condition of the parts.
o
Adjustment of the dispensers.
o
Tightening of the electrical connections on the terminals.
o
CLEANING FILTERS
ENGLISH