Using Your Appliance With The Remote Control; Overview; Inserting Batteries - Runtal FOLIO GLASS Serie Instrucciones De Uso

RUNTAL FOLIO GLASS
5 USING YOUR APPLIANCE WITH THE
REMOTE CONTROL

5.1 OVERVIEW

The Runtal radiators are equipped with infrared remote control,
allowing to communicate room temperature control to the S1 sensor
and to set different operating programs.
When the S1 sensor receives the information the L8 LED flashes to
indicate the reception of communication, it will then stay lit to indi-
cate that the device has been programmed.
For good communication, point the remote control towards the
receiver unit of the appliance.
The distance between remote control and receiver must not exceed
7 m.
Double infrared communication, one at the top and one at the
bottom of the remote control.
36

5.2 INSERTING BATTERIES

• Remove the lid situated at the rear of the remote control.
• Insert two 1.5 V - AAA alkaline batteries in the right position
paying attention to + and – polarity.
• Place the lid back into position.
Both in case of replacement of the batteries and of disposal of the
remote control, batteries must be removed and disposed of in com-
pliance with applicable laws, as they are harmful for the environment.
Low Batteries
When the batteries' tension is lower than 2.2 V, the
"Battery symbol will be displayed for 3 seconds
every minute in the clock zone. The user will have to
replace the batteries.
Once the batteries are installed, the LCD display will be showing all
symbols for 3 seconds.
After this, go to the "Date and time settings" interface – the date will
be flashing, the user will then be able to set the date by using the
"Plus" or "Minus" buttons.
40016966 40016966
ENGLISH
37