Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
TRIGGER SWITCH WITH "LOCK-ON"
BUTTON
Your tool can be turned
"ON" or "OFF"
by squeezing
or
releasing the trigger. Your tool is also equipped with "Lock-ON"
button, located on the left side of the trigger handle, that allows
for continuous operation without holding the trigger. The "Lock-
ON" is a convenience for long cutting operations.
NOTE:
Switch can accommodate
a padlock with a shackle of
up to 3/16"
in diameter
(not provided
with tool) to prevent
unauthorized use.
TO LOCK SWITCH ON: Squeeze trigger, depress button and
release trigger.
TO UNLOCK
THE SWITCH: Squeeze
trigger
and release it
without depressing the "Lock-ON" button.
m
If the "Lock-ON"
button is continuously
being
depressed, the trigger cannot be released.
"LOCK-ON"
BUTTON
SWITCH
To prevent serious personal injury, always disconnect the plug for the power source before changing wheels, or
making any adjustments on the tool.
Removing and Installing Wheels
1. Raise wheel guard as shown in (Fig. 3), push in spindle lock
(Fig. 1), and loosen the hex head bolt in the center of abrasive
wheel by rotating counter-clockwise
with the wrench provided.
2. Remove the hex head bolt, outside flange and abrasive wheel
(Fig. 3).
3. Carefully install the new abrasive wheel onto the spindle shaft
and replace outside flange and hex head bolt.
4. Press in spindle lock and tighten hex bolt with the wrench
provided (A-i-i-ENTION: DO NOT OVERTIGHTEN).
Whenever replacing a wheel, always adjust the
depth stop
bolt to prevent
the wheel from
cutting into the surface the tool is resting on. Failure to make this
adjustment may result in serious personal injury.
SPINDLE
SHAFT
/
INSIDE
FLANGE
RETAINING
RING
_ABRASIVE
WHEEL
OUTSIDE
FLANGE
DEPTH STOP
ADJUSTMENT
BOLT
LOCK NUT"
SPACER
(THINNER)
ADAPTER
(THICKER)
HEX HEAD
BOLT
-6-
Publicidad
Tabla de contenido
