Outside Back Exhaust; Remove Blower Plate; Attach Mounting Plate To Wall - Haier HM1630 Manual Del Usuario

English
English
B. OUTSIDE BACK EXHAUST
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Blower Plate
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
Make sure the screws for the blower motor and blower plate are securely
tightened when they are reinstalled. This will help to prevent excessive vibration
Make sure the motor wiring has been properly routed and secured, and that
the wires are not pinched.
B1. PREPARING THE REAR WALL FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear
wall for outside exhaust.
Read the instructions on the REAR
WALL TEMPLATE.
Tape it to the rear wall, lining up with
the holes previously drilled for holes A
and B in the wall plate.
Cut the opening, following the
instructions of the REAR WALL
TEMPLATE.
B2. REMOVE BLOWER PLATE
Remove and save the screw that holds the
blower plate to the microwave. Lift off the
blower plate.
17
(HORIZONTAL DUCT)
Blower Plate
Back of
Microwave