Mount The Microwave Oven - Haier HM1630 Manual Del Usuario

10. Attach the exhaust adaptor to the
rear of the oven by sliding it into the
guides at the top center of the back of
the oven. Push in securely until it is in
the lower locking tabs. Take care to
assure that the damper hinge is
installed so that it is at the top and that
the damper swings freely.
B6. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION
AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the
nylon grommet around the power cord
hole to prevent cutting of the cord.
1. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2. Rotate front of oven up against cabinet
bottom.
3. Insert a self-aligning screw through top
center cabinet hole. Temporarily secure
the oven by turning the screw at least two
full turns after the threads have engaged.
(It will be completely tightened later.) Be
sure to keep power cord tight. Be careful
not to pinch the cord, especially when
mounting flush to bottom of cabinet.
4. Attach the microwave oven to the top cabinet.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Self-Aligning Screw
Microwave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Adaptor
Guide
NOTE: We recommend using filler
blocks if the cabinet front hangs below
the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
NOTE: When mounting the
microwave oven, thread power
cord through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven by
pulling cord.
2
English
Back of
Microwave
Guide
Locking Tabs
1
20