Aligning The Wall Plate - Haier HM1630 Manual Del Usuario

English
Hole A
Wear gloves to avoid cutting fingers on sharp edges.
D. ALIGNING THE WALL PLATE
1. Draw a vertical line on the wall at the center of the 30" (76.2 cm) wide space.
2. Use the mounting plate
plate on the wall, making sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets with front overhang.
Line up the notch and centerline on the bottom of the mounting plate to the
centerline on the wall.
3. While holding the mounting plate with one hand, draw circles on the wall
at holes A, B, C and D (see illustration above/actual plate marked with
arrows). Four holes must be used for mounting.
NOTE: If neither C nor D is in a stud, find a stud somewhere in area E and
draw a fifth circle to line up with the stud. It is important to use at least one
wood screw mounted firmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
4. Drill holes on the circles. If there is a stud, drill a 3⁄16" hole for wood screws.
For holes that don't line up with a stud, drill a 5⁄8" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
11
Centerline
Notches
Hole C
Area E
CAUTION:
as the template for the rear wall. Place the mounting
Draw a Vertical
Line on Wall
from Center of
Top Cabinet
Hole B
Hole D