Danby DDW396W Manual Del Propietário página 9

Lava platos a contador
Ocultar thumbs Ver también para DDW396W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
POSSIBLE
CAUSE
POSSIBLE
SOLUTION
Dishwasher
will
not start
• Dishwasher
not receiving
• Check electrical connection
electrical power,
Fuselcircuit
breaker,
• Close and latch door
• Level unit
• Door is unlatched
. Dishwasher not level
Dishes not clean
• improper loading.
• Incoming water temperature
not hot enough
Spray arm not rotating freely
• Not enough detergent andlor
improper detergent being used
• Improperly prepared dishes
• Water inlet hose kinked/bent
due to improper installation.
• Arrange dishes so spray action
reaches all surfaces
• Do not overload dishwasher,
• Increase water temperature
•Check spray arm to make sure
nothing (i e, cutlery) is obstructing
spray arm rotation,
• Check if fitter screen has
become dislodged and
obstructing
spray arm rotation
- Use more dishwasher detergent
Detergent to old replace
• Do not use detergent that is
hard or caked
• Use only a recommended
dishwasher detergent.
• Excess food soil and liquids
should be removed from dishes
before loading,
. Eliminate kink or bend from
inlet hose,
Chipping
or breaking
glassware
• Improper loading of dishes,
• Do not ovedoad dishrack,. Load
glasses on the upper rack only,
not over dishrack pins. Glasses
loaded over dishrack pins are
not properly supported and
subject to damage.,
Water remains in bottom
of dishwasher
• A small amount of water
(in sump area) is normal,
• Excessive amount of water;,
Cycle not completed
• This is necessary
to keep the pump
primed and is drained automatically
at the beginning of each cycle
• Allow dishwasher to complete
full cycle

Publicidad

Tabla de contenido
loading

Tabla de contenido